People when opting for a particular car or a vehicle, will look for its mileage, name, making etc. now-a-days they look for the added facilities also. They want vehicles which are economic and which will provide latest features. These may include music systems also. Customers prefer listening to music when they are on a long drive. Thus the devices like music systems, radio, speakers are fixed in the cars. If they do not work, they can be repaired or changed. There are systems available in the markets for this. This article will tell you how to install a jeep wrangler radio.

You should take the following things for the installation of a new wrangler radio in your jeep. They are panel tool, Phillips screw driver and a wrench of 10 mm. The first thing needed for this is you should remove any tapes, CD which is already running in the system which you are going to remove. The next thing is you should turn off power of the vehicle. Then the negative connection of the battery should be removed so that you can avoid any short circuits or shocks that you might incur during its installation.

Then take your next thing that is the panel tool. With the help of it remove the trim panel. For that first find its location. It is located at the dash’s top. It has got heating vents and AC. This trim panel is pried up because the panel’s top position is almost exposed. The receiver is totally surrounded by its top.

Two screws are provided on the receiver’s top side. They will be seen after the vent is peered in the previous step. They are removed. The trim is peered off, from the receiver with the help of the panel kit. Once it is peered you will observe four screws, on the radio’s edges. These are also removed.

The panel for climate control is found beneath the opening of the radio. There are screws provided to hold this in position. It is unscrewed. Then the glove box is opened. The strap used for retaining purpose is drawn out. The box is lowered. The opening in the box will help you to remove the bolt. This bolt is used to keep the rear support of the radio in position. This can be accomplished with the help of a wrench.

Now the radio is taken out. There are wires connected to its back side. These wires are disconnected. Similarly the antenna is removed.

After the older radio is disconnected, the new one can be plugged in the same manner as it was connected formerly. This is done by placing the wires in the harness plug and in the antenna. The radio is slid back through the opening of the dash. The screws are then replaced by using the wrench. This is done so that the new radio is supported. Then the dash is replaced in the same way as it was removed.

Thus the article would have given you guidelines on how to install a jeep wrangler radio. The sequence of steps and connections has to be kept in memory. This will make your installation process quick and easy. If wrong connections are made, the device will get spoiled.

Want to find out more about Auto, then visit Author Name’s site on how to choose the best Car Audio for your needs.

Related Content

Subscribe to the post comments feeds or Leave a trackback